Digiop BLK-IPD104 User Manual download pdf (Page 7)

5H.264 Indoor/Outdoor Dome IP Camera

SECTION 2: INSTALLATION AND SETUP

a. Unplug the extension cable from the camera electronics and remove it from the camera.

b. Install a conduit tting onto the bottom of the base.

c. Install a junction box close enough to the camera for the extension cable LAN and power connectors to be in the box.

Attach the conduit for the junction box to the conduit tting on the bottom of the camera base.

9. Place the base seal over the base, aligning the holes for the mounting screws. Attach the camera and seal to the surface with

three screws. Skip to step 15.

10. Unplug the extension cable from the camera electronics and remove it from the camera.

11. Remove the conduit port plug on the side of the base and install it in the cable port in the bottom of the base.

12. Install a conduit tting onto the side of the base.

13. Place the base seal over the base, aligning the holes for the mounting screws in the base with those in the seal. Attach the

base and seal to the mounting surface with three screws.

14. Install a junction box with conduit close enough to the camera for the extension cable LAN and power connectors to be in

the box. When installing the junction box, attach the conduit to the tting on the side of the camera base.

15. Route the extension cable Molex

connector end into the camera and re-attach it to the electronics.

16. Remove the protective cover on the camera lens.

2.4 Connections

Connections to the camera for audio in and out (microphone and speaker), D/I sensor, alarm, video out BNC, and RS-485 control are

made through the 11-pin terminal block.

11-pin terminal block

1 2 3 4 5 6 7 8 9 10 11 12 ... 34 35

No comments

Digiop BLK-IPD104 User Manual Page 7