Digiop BLK-IPD104 User Manual download pdf (Page 11)

9H.264 Indoor/Outdoor Dome IP Camera

SECTION 2: INSTALLATION AND SETUP

To connect an RS-485 device wiring to the camera:

1. Route RS-485 device wiring through the cable channel and into the camera base housing.

2. Strip 1/4” of insulation from the wires and insert them into the terminal block. Observe the signal polarity shown in the

schematic.

2.4.5 Video out connection

The camera provides pins on the terminal block to attach a local video monitor. A cable extension with a BNC connector is included

in the packaging with the camera. When needed, attach the video cable to the terminal block as shown in gure below.

Local video cable connection

2.4.6 LAN and power connections

1. Route a LAN drop cable into the camera and plug it into the LAN connector. If the camera is powered through the LAN cable,

DO NOT apply power to your camera at this time.

LAN

connector

Power

connector

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 34 35

No comments

Digiop BLK-IPD104 User Manual Page 11